Gi pro problem

[fastone4700]

Just hooked up my gi pro on 01 busa.
All i geet is l flashing then 1 stays flashing
has anybody else had this before. The original owner said it was unlocked when i bought it to do over 300 but i can't see where he unlocked it. Are there different types or only 1.
if i go to gear 6 then down it reads it as 1.

[Pommie]

Possibly the gear position sensor faulty. Thats how I found out mine was buggered when I fitted a Gipro TRE

[fastone4700]

Do you know what they are worth as i just spoke to previous owner and he said suzuki dealer modded the gear position sensor.

[Pommie]

If your lucky someone on here might have one, a wrecker is about 30 or 40 bucks, mine from the dealer was 116 I think. theres is a mod you can do to them that involves silicon I think but cant remeber, it'll be on here somewhere cos someone here will of done it. You can test the GPs if you have a volt meter. Not a hard job. On the downloads section there is a manual you can download, think it has the readings in there and how to do it

[Volvi]

had the same prob then discovered my gps was modded. replaced it from wreckers for $20. beware when replacing to remove clutch basket discs in one hit ie leave them on its hub.

[Pommie]

yeah they a bit of a worry. I marked the outer edge of mine so they all went back in the same place

[fastone4700]

just pulled clutch apart and changed gps to standard now gi pro works fine needed 20cfm compressor and a decent compressor to undo main nut.
all works fine now while i had it apart did oil change and meshed in the fairings.
i used a ryco z444 oil filter which fits fine and cost $10 it is made for suzuki bikes by ryco.
My next mod will be undertail mod if anybody has done i am interested to know what it looks like.