New TRE, now the FI light?
|
New TRE, now the FI light?
|
|
29-10-2007, 04:57pm
Hey guys. Was curious if you could help. Just fitted my new TRE. Now when I turn the bikes ignition on, get the usual dial and dash lights check, but the "FI" light stays on. Can start the bike, seems to run ok, FI light stays on. Decided not to leave the bike running just in case. Any clues?
29-10-2007, 07:02pm
Unplug the tre and see if it stops or see the post at the top of the tech pages about busa codes.
29-10-2007, 07:54pm
Also ensure that you plugged the TRE into the correct plug joint.
AND, some TRE's have been known to be faulty with dry solders etc. If you are in a position to borrow or test someone else's TRE it will probably help a lot.
"If time catches up with you. You're going too slow!"
Regards BUSGO
30-10-2007, 08:50am
Hi Tito,
I'll go with the first one Busgo said. The correct plugin piont is the one lower down under the tank on the wiring loom under the seat, not the one up near the tank. The one you're after is down closer to the breather hose that comes from the air box where it goes on the back of the motor or gear box. Gaz
30-10-2007, 06:34pm
Busgo and Gaz,............................genius.
 What a farkwit, plugged it into the wrong one. As you said, the one closer to the seat is the one, not nearer the tank. Also, the correct one is the white one, not the black one. Cheers boyz. Very, very helpful. Took it for a spin after sorting it tonight and found it has fixed the problem I posted in my other thread. No more stuttering under sudden acceleration, and it doesnt back fire anymore. Thanks again.
|
|
« Next Oldest | Next Newest »
|
Contact Us
