Value of binned bike.
#2
If you don't want to fix her up, then part the bike out.

you will get more for it apart than as a wreck. It'll just take

a bit longer to get some of your money back. Are they going

to right it off or

There are a lot kit car guys that'll take that Bad Ass Busa

Donk off your hands and give you some good coin for it

Just my 2 cents worth......

but if you want to sell the whole bike, I'm

sure there will be a few people that will put there hand up
Regards Richard

You're the guy that'll be sneaking out of your bedroom at three o'clock in the morning to look at your bike. Paul Teutul,Sr. American Chopper
Reply


Messages In This Thread
Value of binned bike. - by Timj - 08-01-2007, 08:51pm
Re: Value of binned bike. - by Fat Busa Racing 1347 - 08-01-2007, 10:03pm
Re: Value of binned bike. - by Timj - 08-01-2007, 11:02pm
Re: Value of binned bike. - by Blackzook - 09-01-2007, 05:54am
Re: Value of binned bike. - by Timj - 13-01-2007, 11:36am
Re: Value of binned bike. - by BEAR - 13-01-2007, 12:32pm
Re: Value of binned bike. - by BUSGO - 13-01-2007, 02:34pm
Re: Value of binned bike. - by Timj - 13-01-2007, 03:35pm
Re: Value of binned bike. - by BEAR - 14-01-2007, 09:34am
Ok - by Timj - 14-01-2007, 03:12pm
... - by Throwdown - 15-01-2007, 06:54pm
Re: ...TimJ - by BEAR - 15-01-2007, 10:24pm
Black's the GO - by Fat Busa Racing 1347 - 15-01-2007, 10:45pm
Re: Black's the GO - by Timj - 15-01-2007, 10:59pm
contact - by hayabusa1300 - 16-01-2007, 10:50am
Re: contact - by Timj - 16-01-2007, 02:51pm
Every Panel - by gazza414 - 16-01-2007, 04:10pm
Re: Every Panel - by Timj - 16-01-2007, 05:10pm
Re: Every Panel - by REVIT13 - 16-01-2007, 09:32pm
Re: Every Panel - by Timj - 16-01-2007, 10:30pm
Re: Every Panel - by Maggot1300 - 16-01-2007, 11:52pm
Re: Every Panel - by RaZ80 - 17-01-2007, 07:17am
Re: Every Panel - by Timj - 20-01-2007, 06:39pm
Re: Every Panel - by BEAR - 20-01-2007, 06:54pm
Re: Every Panel - by HAYABUSA ROD - 20-01-2007, 08:29pm
Re: Every Panel - by pan - 20-01-2007, 09:34pm



Users browsing this thread: 1 Guest(s)