Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Gen 2 1441 with stock head

Gen 2 1441 with stock head
Maj Offline
Law Breaker!!!
VIC Member
Posts: 2,186
Threads: 58
Joined: Mar 2007
Reputation: 13
#7
10-11-2011, 08:08am
You would need to check valve guide clearance, i believe there good to .395 or so lift but if getting close its always good to check , and not hard to drive the guides in deeper while the head is off
Would need upgrade valve springs from APE also,
You getting the piston/cyl kit from APE ?
Find
Reply


Messages In This Thread
Gen 2 1441 with stock head - by G-MAN - 08-11-2011, 08:27pm
RE: Gen 2 1441 with stock head - by simmo - 09-11-2011, 07:46am
RE: Gen 2 1441 with stock head - by G-MAN - 09-11-2011, 12:35pm
RE: Gen 2 1441 with stock head - by Maj - 09-11-2011, 05:54pm
RE: Gen 2 1441 with stock head - by G-MAN - 09-11-2011, 07:32pm
RE: Gen 2 1441 with stock head - by BLACKZOOK - 09-11-2011, 06:47pm
RE: Gen 2 1441 with stock head - by Maj - 10-11-2011, 08:08am
RE: Gen 2 1441 with stock head - by G-MAN - 10-11-2011, 12:08pm
RE: Gen 2 1441 with stock head - by Maj - 10-11-2011, 05:08pm
RE: Gen 2 1441 with stock head - by simmo - 10-11-2011, 06:27pm
RE: Gen 2 1441 with stock head - by G-MAN - 10-11-2011, 06:52pm
RE: Gen 2 1441 with stock head - by Maj - 11-11-2011, 07:23am
RE: Gen 2 1441 with stock head - by fasterfaster - 11-11-2011, 07:42am
RE: Gen 2 1441 with stock head - by Maj - 11-11-2011, 11:00am
RE: Gen 2 1441 with stock head - by GRUNTMAX - 12-11-2011, 11:40am
RE: Gen 2 1441 with stock head - by G-MAN - 12-11-2011, 06:32pm
RE: Gen 2 1441 with stock head - by G-MAN - 12-11-2011, 08:05pm
RE: Gen 2 1441 with stock head - by G-MAN - 27-08-2012, 08:13pm
RE: Gen 2 1441 with stock head - by BLACKZOOK - 28-08-2012, 10:46pm
RE: Gen 2 1441 with stock head - by G-MAN - 29-08-2012, 02:02am
RE: Gen 2 1441 with stock head - by twistgrip - 29-08-2012, 05:59am
RE: Gen 2 1441 with stock head - by BLACKZOOK - 29-08-2012, 08:10pm
RE: Gen 2 1441 with stock head - by G-MAN - 30-08-2012, 03:03am



Users browsing this thread: 1 Guest(s)