Headlight bulb

[#CAS#]

Dale, the easiest way is to remove the nose, you will get full access to it.
1-Roll back the mirror rubbers, undo the bolts holding them on.
2-Un bolt the upper infill panels, do not forget the 1 in front of the ignition switch. There are also a couple of push pins do not forget them.
3-Undo the 3 bolts on either side fairing.
4-The nose should now be held on by the pins behind the dash. Stand at the front of the bike with the wheel between your knees, hold onto the nose and pull towards you, do not pull all the way away from the bike as there is wiring attatched.
5-The wiring loom has a plug, just un plug it and you are good to remove the nose completely.
6-Place the nose headlight side down on a towel or something else that wont scratch it.
7-You will be able to see the back of the headlight clearly. Unplug the wires from the respective globes, remove rubber boot. There is a wire holding clip, squeeze it together to remove it. The globe is now free to remove.
8-Put new globe in.
To put it back together do everything in reverse.

Hope it helps.