07-05-2006, 10:49pm
remove the back wheel and get yaself a 1 inch hole saw roughly work out where the lock is by looking at the pillion seat and then drill a hole through your rear guard then same as pete says get a torch and find the lock and a nice little flat blade screwdriver will do the job once done go to hardware and find a 1 inch rubber gromet and plug the hole that way if you ever do it again it is an easy solution as for levering the hump and sliding metal between paint I would do that only as a last resort Cheers Bill
THE BLINGAHOLIC
<i></i>
THE BLINGAHOLIC
<i></i>