Ram Air Mesh

[jamesallan]

Ok i dug out my nose cone dont realy no why i replaced it with a new one only has verry light scratch on it .
So what is best way of getting mesh out without damage to mesh or nose i was thinking of a solder iron just to touch plastic a quick pull away of mesh .
Pm me your Address James

Rod,

Thats great news youre a , not sure on the best way to release the mesh as mine where butchered on with bog mix or something like that from dodgy brothers incorporated. Perhaps the solder iron will work or even a sharp blade. Sounds like they are plasti moulded - would that be right ? I have used a mini heat blower for something similar.

Sending PM

---

I think James gets the drift.
I'm sure the bike will be mint condition when completed.

Yep you know how these things go, you start off doing one bit then it snow balls from there. I'm lucky to have a second bike to ride that doesn't warrant restoration hands on it - yet * lol.