Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Clutch Barnett or Energy one

Clutch Barnett or Energy one
simmo Offline
Gen 3 owner

NSW Member
Posts: 5,999
Threads: 193
Joined: Mar 2007
Reputation: 11
#8
14-12-2009, 05:22pm
(14-12-2009, 04:27pm)playswithnitro Wrote: Energy One plates are always parallel within 0.02mm.
Barnett are lucky to get within 0.25mm. I have seen them out of whack by up to 0.5mm
Started importing Energy One plates for our fuel bike after giving up on Barnett.

Cool I have run Barnett in my old copper one with no problems
I got a set of Energy ones about 6 months ago (got the kit but have not used them yet but I do like the look of themPi_thumbsup)
Thanks Mick
Find
Reply


Messages In This Thread
Clutch Barnett or Energy one - by horone1 - 13-12-2009, 05:20pm
RE: Clutch Barnett or Energy one - by jason - 13-12-2009, 05:56pm
RE: Clutch Barnett or Energy one - by Maj - 13-12-2009, 07:45pm
RE: Clutch Barnett or Energy one - by Legend - 13-12-2009, 09:09pm
RE: Clutch Barnett or Energy one - by horone1 - 13-12-2009, 09:49pm
RE: Clutch Barnett or Energy one - by GRUNTMAX - 14-12-2009, 10:25am
RE: Clutch Barnett or Energy one - by Legend - 14-12-2009, 06:00pm
RE: Clutch Barnett or Energy one - by simmo - 14-12-2009, 05:22pm
RE: Clutch Barnett or Energy one - by Maj - 14-12-2009, 06:59pm
RE: Clutch Barnett or Energy one - by Camel - 15-12-2009, 10:26am



Users browsing this thread: 1 Guest(s)