Contact Us
12-04-2008, 09:04pm
Spacer plate, no gakets(*) copper coat both sides.
Head gasket-new, I dont use any coating.
Head gasket-used, pull apart and coppercoat all sides remember which way it went together.(**)
* check deck hights first before fitting rings etc.
** If you torque down head more than stock (which you no doubt will) use new head gasket as it will be squashed to hell!
Ive stopped using hylomar as its a bit too good and gaskets had to be replaced when you could have reused them ie chev's etc.
Leonard.
Head gasket-new, I dont use any coating.
Head gasket-used, pull apart and coppercoat all sides remember which way it went together.(**)
* check deck hights first before fitting rings etc.
** If you torque down head more than stock (which you no doubt will) use new head gasket as it will be squashed to hell!
Ive stopped using hylomar as its a bit too good and gaskets had to be replaced when you could have reused them ie chev's etc.
Leonard.