+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Turbo Talk (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=41)
+--- Thread: SPACER PLATE (/showthread.php?tid=9666)
SPACER PLATE - Darwin busa 01 - 12-04-2008
Spacer plate, do i use gaskets or just use hylomar spray ????
Cometic head gasket do you fit as is ore spray with hylomar ????
RE: SPACER PLATE - Legend - 12-04-2008
Spacer plate, no gakets(*) copper coat both sides.
Head gasket-new, I dont use any coating.
Head gasket-used, pull apart and coppercoat all sides remember which way it went together.(**)
* check deck hights first before fitting rings etc.
** If you torque down head more than stock (which you no doubt will) use new head gasket as it will be squashed to hell!
Ive stopped using hylomar as its a bit too good and gaskets had to be replaced when you could have reused them ie chev's etc.
Leonard.
RE: SPACER PLATE - Legend - 12-04-2008
Just realised your using stock rods and pistons, right?
Disregard the deck height checking part!!!
Leonard.
RE: SPACER PLATE - Darwin busa 01 - 12-04-2008
Thanks for that info it is a big help...
Yes using stock rods and pistons
Thanks mate.........
RE: SPACER PLATE - hawkwind - 16-04-2008
hey leonard is that the permatex spray on copper ? and is that to replace the viton coating on MLS head gaskets (used ones)
cheers
RE: SPACER PLATE - Legend - 16-04-2008
Thats the one, Gary!
Leonard.