Chain wax? Need some advice

[Batfink]

nice simple vid Lucky

I only use kero for cleaning and it was interesting to hear that a penetrating lube like WD40 will end up drying out your inner rollers by dislodging the inner grease. That's why I have always been suspect about using a penetrating lube.

I did my last chain by breaking 3x cheap tooth brushes LOL I need to get that gunge brush. It was funny though as I sat on the ground scrubbing and drinking beer I was thinking about making a block a bit like the chain ninja for lubing but as all my ideas it's already been done LOL
However I was thinking of my block being about 4 inches long, running on air and incorperating both cleaning with rotating scrubbers, blow drying and lubing. Guess I might keep that idea to myself so sshhhhhhhhhhh

[Shordy]

I ordered one of these brushes a couple of weeks ago.
I haven't received it yet so I'm not sure what it's like, but hey, $3.62 delivered.
I'll give it a crack.

http://www.ebay.com.au/sch/i.html?_from=...+&_sacat=0

[Corpsedealer]

Not a bad little vid. I will be making a chain Ninja as soon as I get home, I will use it with the can of pro honda moly spray I have ordered.

[captainrob]

[Shordy]

I bought a couple of these a while back. The gap is too narrow for our chains, but one side clicks off and the right angle is still useful. Probably worth the price!



I wondered about the size, not knowing about them clicking apart, I had already considered doing a hacksaw job on it......
Worse scenario is I'll use the other end to get the bugs out of the air intake meshes....lol

[Kendo]

I use these brushes. You can get replacement brush heads for them as well.

http://www.drcproducts.com/tool/d59-22-001/index.html

Like how the Grease Ninja works, that is how I have always lubed my chains with the little straw attachment, always along the chain plates.

[big kev]

This is a very dirty subject men talking about what lube they use

What kinda forum are you running here

Lmao

Sent from my SM-G920I using Tapatalk

[Corpsedealer]

[Rev004]

[captainrob]

[iano]

Made my own...
Worked oot well..









[/QUOTE]

[Batfink]

Now that is somethign a 3D printer would be great making... specially getting the internal tunnels to the right place!

Might have to look at buying a 3D printer next year hahahahahaaaa

[Corpsedealer]

Thanks Iano
Mine looks like it was chiseled from a lump of coal! LOL
Looks awsome!

[captainrob]

You guys have far too much time to spare!

[Batfink]

Hey Capt., some people whittle, some watch porn but we make shyte you dan otherwise buy lol