my easter project :)

[RaZ]

lol setup

[abusa]

Ha Ha dont know how I missed that, now Loafie is out with the whips LOL

[arthur dunga]

On the two lots of yoshi's i've had for the busa ( the 2 trs cans fitted to the stock system, & now the 4into1) there was a removable baffle.There was a grub screw at the end of the can ,may have had a tack weld, remove this then pull a short baffle out the end, like pulling a tooth with a pair of plier's.

[DjPete]

i know how to get the end off...on mine its rivetted...but if I remember it is not so easy to get the baffle out ...or is it?
mines same as Raz's

Nothing on this on Google

[arthur dunga]

Not the whole f*&^ing end cap. On the under side of the round thingy at the end of the can.

[RaZ]

mm, going to suss it out tomorrow & see if I can find anything like that :) another project Mr DJ? :)

Thanks a million again Arthur :) will have to buy you a beer one day

[DjPete]

Not the whole f*&^ing end cap. On the under side of the round thingy at the end of the can.

yes mr dunga,
thats what i mean the end bit...about 8 rivets if i remember
no grub screw on mine.
if i look down the exhaust besides getting soot on my nose i can see right to the end...maybe i don't have the baffle and i am just deaf from all the doof doof music??
Hey?? what??

[RaZ]

There was a grub screw at the end of the can ,may have had a tack weld, remove this then pull a short baffle out the end, like pulling a tooth with a pair of plier's.

Thats what I will be looking for... in fact stuff it :) I am grabbing a torch to go look

EDIT: Nope... nothing like that for me - its totally sealed up with rivets for each end... however - very unhappy find :( the bottom of my new can now has a ding in it - had a pillion today over bumpy road & didn't adjust my rear spring - the pick up knob for the swing arm has connected with the bottom of the can & dinged it :(

oh well... guess its a reason to get a tri oval or something

[DjPete]

it aint there i just looked raz

[DjPete]

[RaZ]

should buff out right LOL

when I googled for it I found different RS3 can models... if that makes sense & some did have this bung that Arthur is talking about.

guess we just lucked out? :) however as Jay pointed out after fitting it - now I have the full system I can fit any slip on I want to it... mmmmm

[DjPete]

done
got another head full of wadding hair out.
I just have straight pipe with wadding around as far as i can see.
no baffles as such

[BUSGO]

The older model Yoshis didn't have removable baffles because they were meant for track use only.
It is only the last couple of years that the baffles have been available and probably not on all model cans.

[DjPete]

thanks Busgo that explains it.
Mine must be at least 5 yrs old

[RaZ]

well cool - I went for a bit of a local ride over the dandys today. the tip in and cornering seems heaps easy now :) all in all - wish now I had gone a full system years ago lol