+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Technical Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=5)
+--- Thread: pair valve block off plates (/showthread.php?tid=7010)
Pages:
1
2
pair valve block off plates - arthur dunga - 03-05-2007
where can i get some of these pair valve block off plates,i'm installing a new exhaust so i gess it would be good to remove this plumbing?
RE: pair valve block off plates - xhiler8r - 03-05-2007
if you know how to use a welder or an oxy I just cut my tubes about 10mm from the flange and squashed them then braised the ends up But then again the pair valve is of no use now with the bits cut off
RE: pair valve block off plates - Tag 13 - 04-05-2007
try that
http://cgi.ebay.com/ebaymotors/Suzuki-GSXR-Hayabusa-Exhaust-Pair-Valve-Block-Off_W0QQcmdZViewItemQQcategoryZ35596QQihZ013QQitemZ230121255388QQrdZ1QQsspagenameZWD1V
RE: pair valve block off plates - Maj - 04-05-2007
tech screw,
RE: pair valve block off plates - Gnarbunkle99 - 04-05-2007
I would be inclined to plumb the PAIR valve to suck, when she doesnt suck anymore, get rid of it and block off.
RE: pair valve block off plates - arthur dunga - 04-05-2007
great, i 'm sure i'll sort something out from that lot
RE: pair valve block off plates - DisPlaCeD - 06-05-2007
EDIT: used search.. don't worry....
RE: pair valve block off plates - arthur dunga - 06-05-2007
went to bunnings & brought 4mm strip of ally & made some,seems to have done the trick.
RE: pair valve block off plates - arthur dunga - 06-05-2007
there were 2 hoses to the pair valve 1 from the air box ,(i've blocked that off)but the smaller hose what do i do with that?
RE: pair valve block off plates - Gnarbunkle99 - 06-05-2007
Rip it out, its a vacuum line from the throttle bodies, trace it uphill and block at throttle body.
RE: pair valve block off plates - RaZ - 04-03-2008
Just wanting to confirm all this above?
will be fitting my new system this weekend...
RE: pair valve block off plates - AntsBuza - 04-03-2008
Aly plate is also what I used.
RE: pair valve block off plates - jzbusa - 04-03-2008
Will be making ally plates also
RE: pair valve block off plates - BUSGO - 04-03-2008
I am a firm believer in NOT blocking off the pair at all.
I don't believe it does anything at all for performance and it is there for a purpose.
So what if you get a bit of a backfire at high fuel flow speeds.
It sounds hot if nothing else.
RE: pair valve block off plates - Legend - 04-03-2008
A 6mm tap and 4 short bolts is quicker than making 1 ally plate!
What does the manual say about the pair valve, Busgo?
Leonard.
