brock ct series pipe

[spamanglenn]

[attachment=5830]

tough looking pipe

[NEMESIS]

They dont make it for a gen 1 do they!?

[spamanglenn]

gen2 pipes fit gen1 motors if your prepared to cut the eyelet for the centre stand and the right hand eyelet for the belly wing off the bottom of the motor.It all fits up fine otherwise,thats what i found with my ti force gen2 pipe anyway,otherwise just the can with a gen1 pipe.

[NEMESIS]

Making holes is the least of my problems, sounds good glenn!
Because i like alot of the pipes for the gen2's but they dont make them for the gen1's...

[spamanglenn]

they fit better actually as the gen2 is narrower in the fairings down where the headers are,so that gives you some breathing space on a gen1.If anything the headers sit slightly forward hanging off the standard rear passenger pegs of a gen1 but not enough to be a problem for a single radiator fan setup.

[attachment=5840]

[REVIT13]

nice looking pipe that one and on my coloured bike as well.

brock's do a good exhaust and i may go this path if do more street riding as the short meg can be a tad loud for the boys in the blue if they are having a bad day.

[NEMESIS]

Does it make good power?
Its a full system right?

[Scilaci]

tough looking pipe

Hey do you own this bike in the pictures? Loved the way it has been lowered..If yours how much did it cost and what was done?
Cheers\Scilaci

[spamanglenn]

the gen2 is a promo shot,the gen1 is my bike.

[kawasuki]

the gen2 is a promo shot,the gen1 is my bike.

and it has a TiForce system on it......