Dealer mode tool
|
Dealer mode tool
|
08-12-2010, 01:47pm
Has anyone here got the Gen 1 'special tool' that you plug into the harness to show any stored faults on the ECM?...I presume it works on the same principle as the Bandit device in that it jumps certain pins in the connector. If not does anyone know which pins need to be jumped in order to show any faults on the LCD readout?
Cheers Steve
Smoke me a kipper I'll be home in time for breakfast
08-12-2010, 01:55pm
(08-12-2010, 01:47pm)Aussie Steve Wrote: Has anyone here got the Gen 1 'special tool' that you plug into the harness to show any stored faults on the ECM?...I presume it works on the same principle as the Bandit device in that it jumps certain pins in the connector. If not does anyone know which pins need to be jumped in order to show any faults on the LCD readout? this covers late GEN I / GEN II http://cgi.ebay.com.au/Dealer-mode-tool-...3cb0af356a 
08-12-2010, 02:58pm
Steve on the plug that has the rubber boot over it there are only two wires that go into it on the Gen 1 ................ just bridge them.
Dealer tool = paper clip / split pin / small piece of wire .............. anything that will connect the two wires. 
08-12-2010, 03:32pm
Paper clip worked a treat for me
08-12-2010, 04:18pm
K good to know...dealers probably want $300 for one hey!
Smoke me a kipper I'll be home in time for breakfast
18-12-2010, 03:18pm
(08-12-2010, 04:18pm)Aussie Steve Wrote: K good to know...dealers probably want $300 for one hey!http://www.schnitzracingstore.com/catalo...i_thumbsup: |
|
« Next Oldest | Next Newest »
|
Contact Us
