Contact Us
21-07-2007, 08:14am
Does anyone work in a steel fab shop in Melb??? I need a couple of small counter weights made up. 200mm dia x 20mm thick with a 19mm hole through the middle.
They also need a locking screw of some sort so they can be locked in position on a shaft. Exactly like this one.
http://www.astro.com.sg/images/p-photo-a...counte.gif
Doesn't need to be turned. Can just be flame cut & ground up.
Would be very interested in discussing a price with someone.
OR, if someone has the facility they are willing to "rent" to me & sell me the steel so I can make them myself. Should only take an hr or so if all the gear is there.
They also need a locking screw of some sort so they can be locked in position on a shaft. Exactly like this one.
http://www.astro.com.sg/images/p-photo-a...counte.gif
Doesn't need to be turned. Can just be flame cut & ground up.
Would be very interested in discussing a price with someone.
OR, if someone has the facility they are willing to "rent" to me & sell me the steel so I can make them myself. Should only take an hr or so if all the gear is there.