Holes dont line up.....
#4
You may find these problems there is a slight difference between the 99-2000 models and the 2001 model they have gone to a steel rear subframe so I believe they are slightly wider that's why the grab rails won't interchange either"so I've been told" its not much but enough so that it creates a bad hole alignment. If you decide to take the above advice don't forget to take the washers off or the bolts wont have much thread down in the subframe and strip out that's if you still leave the grab rail on and the the Ventura rack I would say that no one has complained to ventura yet so they dont know
Reply


Messages In This Thread
Holes dont line up..... - by michael - 22-04-2001, 10:07am
Re: Holes dont line up..... - by OhzOne - 22-04-2001, 11:18am
Re: Holes dont line up..... - by busababy - 22-04-2001, 12:47pm
Re: Holes dont line up..... - by Lethal Busa - 24-04-2001, 05:45pm
Re: Holes dont line up..... - by Lethal Busa - 24-04-2001, 05:51pm
Re: Holes dont line up..... - by demeester - 24-04-2001, 05:53pm
Re: Holes dont line up..... - by rocketman - 26-04-2001, 12:13pm
Re: Holes dont line up..... - by busababy - 27-04-2001, 01:18am
Re: Holes dont line up..... - by demeester - 27-04-2001, 10:21am



Users browsing this thread: 1 Guest(s)