Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › General Discussion v
Extreme metal polishing

Extreme metal polishing
GDYUP
Guest
 
#10
11-11-2006, 07:39pm
Good point Rod.

But I'll go with plan "B". (I now have two spares)



I might even carry the factory tool kit for the next time it snaps off! Never needed it until the last few weeks. I think it's in the garage somewhere???

No f*** it! it weighs too much................

Cheers, Phil.
Reply


Messages In This Thread
Extreme metal polishing - by jamie - 01-11-2006, 11:35am
Polished - by GDYUP - 08-11-2006, 12:11pm
Frame Polished............. - by GDYUP - 08-11-2006, 04:02pm
Re: Frame Polished............. - by rev 01 - 10-11-2006, 01:01pm
Re: Frame Polished............. - by GDYUP - 10-11-2006, 05:36pm
Re: Frame Polished............. - by RaZ80 - 10-11-2006, 05:58pm
Re: Frame Polished............. - by Djpete - 10-11-2006, 06:53pm
Re: Frame Polished............. - by GDYUP - 10-11-2006, 09:03pm
Re: Frame Polished............. - by HAYABUSA ROD - 10-11-2006, 11:20pm
Cheesecake alloy - by GDYUP - 11-11-2006, 07:39pm
Re: Cheesecake alloy - by Djpete - 11-11-2006, 11:13pm
Re: Cheesecake alloy - by HAYABUSA ROD - 11-11-2006, 11:36pm
Tool kit - by GDYUP - 16-11-2006, 09:32pm
holder - by rev 01 - 17-11-2006, 08:00pm
Re: holder - by 2k busa rider - 18-11-2006, 12:09pm
Re: holder - by Maggot1300 - 18-11-2006, 01:21pm
Re: holder - by demeester - 18-11-2006, 01:48pm
Re: holder - by HAYABUSA ROD - 19-11-2006, 03:20am
Re: holder - by HAYABUSA ROD - 24-11-2006, 01:35am
Broken - by GDYUP - 25-11-2006, 08:01pm
chrome - by spamanglenn - 25-11-2006, 08:32pm
Cheesecake..... - by GDYUP - 26-11-2006, 08:04pm
Re: chrome - by 2k busa rider - 16-12-2006, 06:00pm
Re: chrome - by 2k busa rider - 28-01-2007, 02:00pm
number plate frames - by jamie - 30-01-2007, 11:14am
Re: number plate frames - by Maggot1300 - 30-01-2007, 01:29pm
Re: number plate frames - by 2k busa rider - 30-01-2007, 05:44pm
Re: number plate frames - by Maggot1300 - 30-01-2007, 06:03pm
plates - by jamie - 02-02-2007, 02:41pm



Users browsing this thread: 1 Guest(s)