29-12-2006, 10:04am
Not sure if I'll bother with a seat pad. If anything, it will be just a show job. ie maybe a few mm of foam under some vinyl. The problem is how to finish the back edge neatly, and where on the hump do you finish it off? Still, hope to be able to play around soon. Should have the mould done this weekend, and then maybe produce the prototype seat next week sometime for trial. Putting all the bracketry in will take a while.
My arse has enough padding, so any extra is just for show really.
My arse has enough padding, so any extra is just for show really.