31-01-2006, 08:00am
Richard better to get a tried and true port job than an experimental , there is combinations of bore size, port size,valve size & cam that yeild good results, Gazza could probably offer good info in this area, also check the "All Motor" at Suzukihayabusa.org & take note of posts on porting from guys like Daikenbusa and Darkfalcon,
Done properly 210 shouldn't be all that hard to achieve, bit like baking a cake.Follow a recipe and you will get the desired result. <i></i>
Done properly 210 shouldn't be all that hard to achieve, bit like baking a cake.Follow a recipe and you will get the desired result. <i></i>