27-05-2016, 06:49pm
75MM inlet mate, here's the filter i have on the way. Should look all right if i get the stencil right and don't balls the hole up!
![[Image: 53620683ac9f2b5bf675ef0f4392fb72.jpg]](http://uploads.tapatalk-cdn.com/20160527/53620683ac9f2b5bf675ef0f4392fb72.jpg)
![[Image: 7d61e9a3d6f3cbe7d578335dccb44793.jpg]](http://uploads.tapatalk-cdn.com/20160527/7d61e9a3d6f3cbe7d578335dccb44793.jpg)
The business end of the fuel tank, now leak free. Loaded the generic power commander fat map and cranked it up apparently i put the fan a little to close to the header tho.. FMU seems to be doing its job, the bov is opening and the boost gauge shows a steady needle.
![[Image: 7d925a18f9ebba5528daef090af05a51.jpg]](http://uploads.tapatalk-cdn.com/20160527/7d925a18f9ebba5528daef090af05a51.jpg)
Tomorrow's job, trim all the fan blades to get it back in balance. Oh and modify the lower rad mount again 😑
So far so good really!
Sent from my GT-I9507 using Tapatalk
![[Image: 53620683ac9f2b5bf675ef0f4392fb72.jpg]](http://uploads.tapatalk-cdn.com/20160527/53620683ac9f2b5bf675ef0f4392fb72.jpg)
![[Image: 7d61e9a3d6f3cbe7d578335dccb44793.jpg]](http://uploads.tapatalk-cdn.com/20160527/7d61e9a3d6f3cbe7d578335dccb44793.jpg)
The business end of the fuel tank, now leak free. Loaded the generic power commander fat map and cranked it up apparently i put the fan a little to close to the header tho.. FMU seems to be doing its job, the bov is opening and the boost gauge shows a steady needle.
![[Image: 7d925a18f9ebba5528daef090af05a51.jpg]](http://uploads.tapatalk-cdn.com/20160527/7d925a18f9ebba5528daef090af05a51.jpg)
Tomorrow's job, trim all the fan blades to get it back in balance. Oh and modify the lower rad mount again 😑
So far so good really!
Sent from my GT-I9507 using Tapatalk