Contact Us
31-03-2014, 04:59pm
ok need to modify a gps
i think i have one here already done , or you can do your own
I will have to check if it was in the back room or shed
basically you remove the silicone potting on the back of the gps then un solder the little resistors and put a light wire (i use electronics cable with 6-7 light wires and shielding as its about the right size to route around the clutch and out the rubber seal)
1 wire per gear except dont disturb N and the black earth wire
while the gps is out you can lightly polish the face with wet/dry to remove old tracks and wear
i think i have one here already done , or you can do your own
I will have to check if it was in the back room or shed
basically you remove the silicone potting on the back of the gps then un solder the little resistors and put a light wire (i use electronics cable with 6-7 light wires and shielding as its about the right size to route around the clutch and out the rubber seal)
1 wire per gear except dont disturb N and the black earth wire
while the gps is out you can lightly polish the face with wet/dry to remove old tracks and wear