Rig Views
#16
(29-03-2013, 12:03am)Dan85 Wrote: Zoro I'm good at doing nothing but being vertical doing it! I woulda been there slaving away.

Dan, there is a saying for offshore work, "Eat till you're tired, Sleep till you're hungry"....

Depending on what the job we're sent to do entails there could be a lot of "non productive" time. Basically if you're not needed outside you dont go out due to the risk of being hurt. Needless to say I have a few hard drives chock full of movies. We can on the rare occasions get flown on and off as required, we end up sitting in a hotel room somewhere doing nothing as well. Its not all hardcore/ flatout work but when there is work to do it is done at "hammer and tong" speed due to rig time costs etc.

Reply


Messages In This Thread
Rig Views - by Zoro - 28-03-2013, 02:48pm
RE: Rig Views - by CaptainRob - 28-03-2013, 03:11pm
RE: Rig Views - by pashnit - 28-03-2013, 03:39pm
RE: Rig Views - by Zoro - 28-03-2013, 05:08pm
RE: Rig Views - by Dale - 28-03-2013, 03:46pm
RE: Rig Views - by revhead - 28-03-2013, 04:47pm
RE: Rig Views - by Dan85 - 28-03-2013, 06:51pm
RE: Rig Views - by Zoro - 28-03-2013, 10:49pm
RE: Rig Views - by BikerBoy - 28-03-2013, 06:58pm
RE: Rig Views - by 06BUSA - 28-03-2013, 09:04pm
RE: Rig Views - by BikerBoy - 28-03-2013, 11:21pm
RE: Rig Views - by Zoro - 28-03-2013, 11:50pm
RE: Rig Views - by Dan85 - 29-03-2013, 12:03am
RE: Rig Views - by Zoro - 29-03-2013, 09:05am
RE: Rig Views - by BEAU - 29-03-2013, 07:39am
RE: Rig Views - by Zoro - 29-03-2013, 09:32am
RE: Rig Views - by CaptainRob - 29-03-2013, 08:16am
RE: Rig Views - by Dan85 - 29-03-2013, 09:19am
RE: Rig Views - by Dan85 - 29-03-2013, 10:40am
RE: Rig Views - by Zoro - 29-03-2013, 10:45am
RE: Rig Views - by Dan85 - 29-03-2013, 10:59am
RE: Rig Views - by jamdonut - 29-03-2013, 11:20am
RE: Rig Views - by Zoro - 29-03-2013, 12:00pm
RE: Rig Views - by Dan85 - 29-03-2013, 12:07pm
RE: Rig Views - by Zoro - 29-03-2013, 12:13pm
RE: Rig Views - by Dan85 - 29-03-2013, 12:18pm
RE: Rig Views - by Zoro - 29-03-2013, 02:17pm
RE: Rig Views - by Zoro - 29-03-2013, 05:42pm



Users browsing this thread: 3 Guest(s)