ok fitted 1x coil today to replace the buggered one,well so i thought ? bike still rooted ,SO,
right while bike was running today ,i grabbed the wiring harness and gave it a good pull ,what the fOOk ,bike jumped up onto 4 cylinders?,ok tank seat back off ,got out the olfa knife cut the harness open at various places ,found a broken power wire for the fan rubbing on the frame, checked all solder joint found the power for the low beam hanging by one thread of wire,then thought id take the battery and computer out ,I lookED close at computer wiring ,a big red wire ,snapped off just sitting there, closer inspection showed it had been repaired in the past ,and has 3 inches of red wire soldered into it ,to make it longer,when i looked at the computer plug there was 2mil of bare wire hanging out of it,i managed to rejoin it with solder, the cable tied it tight to the wire next to it to stop movement,WISH ME LUCK,
right while bike was running today ,i grabbed the wiring harness and gave it a good pull ,what the fOOk ,bike jumped up onto 4 cylinders?,ok tank seat back off ,got out the olfa knife cut the harness open at various places ,found a broken power wire for the fan rubbing on the frame, checked all solder joint found the power for the low beam hanging by one thread of wire,then thought id take the battery and computer out ,I lookED close at computer wiring ,a big red wire ,snapped off just sitting there, closer inspection showed it had been repaired in the past ,and has 3 inches of red wire soldered into it ,to make it longer,when i looked at the computer plug there was 2mil of bare wire hanging out of it,i managed to rejoin it with solder, the cable tied it tight to the wire next to it to stop movement,WISH ME LUCK,