14-07-2012, 02:15pm
Thanks Maj.
Do not worry about the "deceptive" picture.
Oh well, tried, but after slacking off the APE Cam chain tensioner all the way, could not get enough slack in the chain.
Never mind, I'll re-lap all the valves in the ported head & vacuum test all properly, then pull the motor out again, fit the head & put a set of 395/378s back on it & degree properly.
If you have a base gasket/spacer that exceeds thickness of OEM base gasket you will have to re-degree your cams !
![Wtf Wtf](https://www.australian-hayabusa-club.com/MyBB/images/smilies/wtf.gif)
Do not worry about the "deceptive" picture.
Oh well, tried, but after slacking off the APE Cam chain tensioner all the way, could not get enough slack in the chain.
Never mind, I'll re-lap all the valves in the ported head & vacuum test all properly, then pull the motor out again, fit the head & put a set of 395/378s back on it & degree properly.
If you have a base gasket/spacer that exceeds thickness of OEM base gasket you will have to re-degree your cams !
![Wtf Wtf](https://www.australian-hayabusa-club.com/MyBB/images/smilies/wtf.gif)