HELP! Lowering link settings.....
|
HELP! Lowering link settings.....
|
03-07-2012, 04:31pm
(03-07-2012, 09:39am)TheAlchemist Wrote: If Stock is 119 mm between hole centers & you want it 2 " lower (48mm ). If you use the holes with 135 mm centers ( 16 mm longer than stock), at a ratio of 3-1 it should lower the rear by 48 mm 2" between friend's . If Wisdom Comes with Age , I'm one of the Smartest Blokes Here |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
HELP! Lowering link settings..... - by TheAlchemist - 02-07-2012, 11:59am
RE: HELP! Lowering link settings..... - by Greeny_SA - 02-07-2012, 12:48pm
RE: HELP! Lowering link settings..... - by TheAlchemist - 02-07-2012, 03:48pm
RE: HELP! Lowering link settings..... - by TheAlchemist - 03-07-2012, 09:39am
RE: HELP! Lowering link settings..... - by Greeny_SA - 03-07-2012, 04:31pm
RE: HELP! Lowering link settings..... - by TheAlchemist - 04-07-2012, 01:07am
RE: HELP! Lowering link settings..... - by Greeny_SA - 04-07-2012, 12:09pm
RE: HELP! Lowering link settings..... - by bazman - 04-07-2012, 02:06am
RE: HELP! Lowering link settings..... - by TheAlchemist - 04-07-2012, 02:13pm
RE: HELP! Lowering link settings..... - by Greeny_SA - 04-07-2012, 06:12pm
|
Contact Us
