Contact Us
28-04-2012, 11:47am
Hay,
I've just had this same issue on a bike I was fixing up.
The clutch pack and push rods all check out ok, and turns out the clutch master was holding preasure in the system.
I changed out the hole master, and that fixed it.
Everything was fine then.
Maybe put it on a stand, start it in gear, and disconnect the oil line to the slave.
run it for 10 min and see if the clutch cover temp is any better.
this way you will isolate the hydraulics as a possible problem or not!
Let me know how it goes.
I'm in Perth if you need any help.
Axe.
I've just had this same issue on a bike I was fixing up.
The clutch pack and push rods all check out ok, and turns out the clutch master was holding preasure in the system.
I changed out the hole master, and that fixed it.
Everything was fine then.
Maybe put it on a stand, start it in gear, and disconnect the oil line to the slave.
run it for 10 min and see if the clutch cover temp is any better.
this way you will isolate the hydraulics as a possible problem or not!
Let me know how it goes.
I'm in Perth if you need any help.
Axe.