Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Bike won't start without bump / push start ????

Bike won't start without bump / push start ????
rev 01
Guest
 
#8
24-01-2007, 12:23pm
After market levers........been there done that.

You can use the actual after market "lever" but you will need to re fit the OEM safety switch actuation part of your old lever "assembly" to make it work properly.

The dodgy part on the after market "assembly" doesn't push far enough to activate the safety switch
& complete the circuit to the starter & engage it.

I'm not saying the after market's are all like that but the one I used was & I've heard of plenty of others. <i></i>
Reply


Messages In This Thread
Bike won't start without bump / push start ???? - by tenacious - 24-01-2007, 01:28am
Re: Bike won't start without bump / push start ???? - by Turtle - 24-01-2007, 07:27am
Re: Bike won't start without bump / push start ???? - by kev11e - 24-01-2007, 07:57am
Re: Bike won't start without bump / push start ???? - by Heidi1 - 24-01-2007, 10:25am
Re: Bike won't start without bump / push start ???? - by Heidi1 - 24-01-2007, 10:54am
Re: Bike won't start without bump / push start ???? - by rev 01 - 24-01-2007, 12:23pm
Re: Bike won't start without bump / push start ???? - by Heidi1 - 24-01-2007, 02:57pm
Re: Bike won't start without bump / push start ???? - by tenacious - 25-01-2007, 03:51am
switch - by Maj750t - 25-01-2007, 07:35am
Re: Bike won't start without bump / push start ???? - by Busdriver - 25-01-2007, 01:53pm
Re: Bike won't start without bump / push start ???? - by rev 01 - 25-01-2007, 08:01pm
Re: Bike won't start without bump / push start ???? - by tenacious - 26-01-2007, 02:21am
limited......... - by rev 01 - 26-01-2007, 03:31pm



Users browsing this thread: 1 Guest(s)