Contact Us
16-10-2006, 03:59pm
Kev,
I had a similar problem a few years back too.
If you end up wanting to replace the pump, I have a relatively new one here for a 99, it is in good nick the filters and screens are spotless.
If you decide that it is your injectors I also have a set of stock ones that were ultra soniced 3 weeks before they came out of the bike.
From my experience, when it happened to me it was the pump, you can pull it apart and cut out a couple of screens in the base of it, there is also screens in the regulator, and in the injectors too.
Do you still have the foam wrap on the pump? If not Clark Rubber have some stuff you can use to re-wrap it in, tell them where it is going and how hot it will get (over 100c) it is a silver backed foam sheet about 10mm thick, you can get it with or without adhesive backing on it. I have enough of it here if you want it you can have it.
Let us know how you go. <i></i>
I had a similar problem a few years back too.
If you end up wanting to replace the pump, I have a relatively new one here for a 99, it is in good nick the filters and screens are spotless.
If you decide that it is your injectors I also have a set of stock ones that were ultra soniced 3 weeks before they came out of the bike.
From my experience, when it happened to me it was the pump, you can pull it apart and cut out a couple of screens in the base of it, there is also screens in the regulator, and in the injectors too.
Do you still have the foam wrap on the pump? If not Clark Rubber have some stuff you can use to re-wrap it in, tell them where it is going and how hot it will get (over 100c) it is a silver backed foam sheet about 10mm thick, you can get it with or without adhesive backing on it. I have enough of it here if you want it you can have it.
Let us know how you go. <i></i>