Contact Us
25-05-2011, 11:41pm
(This post was last modified: 25-05-2011, 11:51pm by fasterfaster.)
If it's a Gen II then it's a known problem .............. even reported by journos in the first ride reports of the 08 model. Had a guy in Bundy had the problem and not sure how he sorted it or if he even bothered after speaking with me, but it's related to ICS setting.
Needs ICS to be checked and voltage logged during warm up with SDS tool and then ICS to be reset.
PTC heater again checked with sds tool. Would also check that ICS is not sticking when cold ................. do not disconnect ICS from loom within 5 secs of switch off or it will lose it's setting and can only be reset using SDS tool. This will then bring on FI light (Again if it's gen 2)
Needs ICS to be checked and voltage logged during warm up with SDS tool and then ICS to be reset.
PTC heater again checked with sds tool. Would also check that ICS is not sticking when cold ................. do not disconnect ICS from loom within 5 secs of switch off or it will lose it's setting and can only be reset using SDS tool. This will then bring on FI light (Again if it's gen 2)