Contact Us
22-05-2011, 02:03pm
Hope someone can help me out with this:
I removed the front sprocket cover to clean out the accumulated chain lube gunk.
The problem I now have is, when trying to bleed the clutch fluid, I can't get any pressure to build up when pumping the lever (been at it for 30 minutes).
I have a workshop manual and followed the instructions to the letter (more or less).
One point of note is that I had to do a quite bit of hammering (soft head) to remove one of the clutch fluid reservoir cap screws. Is it possible that this has damaged the master cylinder?
Any ideas or suggestions would be great.
Thanks
I removed the front sprocket cover to clean out the accumulated chain lube gunk.
The problem I now have is, when trying to bleed the clutch fluid, I can't get any pressure to build up when pumping the lever (been at it for 30 minutes).
I have a workshop manual and followed the instructions to the letter (more or less).
One point of note is that I had to do a quite bit of hammering (soft head) to remove one of the clutch fluid reservoir cap screws. Is it possible that this has damaged the master cylinder?
Any ideas or suggestions would be great.
Thanks