Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Verlosity stacks

Verlosity stacks
BEAU Offline
I wanna go fast.
VIC Member
Posts: 1,463
Threads: 67
Joined: Sep 2010
Reputation: 3
#9
28-01-2011, 07:32pm
(28-01-2011, 04:45pm)drworm Wrote: Dont get too caught up with the cnc part. CNC only ensures repeatability, not quality. The ports are ported by hand then digitised to create the cutter paths. If the initial porting that was digitised was crap, then the cnc machined ports will also be crap.

Though I am after repeatability of intake length...
Find
Reply


Messages In This Thread
Verlosity stacks - by BEAU - 27-01-2011, 03:03pm
RE: Verlosity stacks - by Rainbow7 - 28-01-2011, 11:12am
RE: Verlosity stacks - by BEAU - 28-01-2011, 11:21am
RE: Verlosity stacks/CNC porting - by BEAU - 28-01-2011, 02:57pm
RE: Verlosity stacks - by BikerBoy - 28-01-2011, 03:01pm
RE: Verlosity stacks - by BEAU - 28-01-2011, 03:18pm
RE: Verlosity stacks - by drworm - 28-01-2011, 04:45pm
RE: Verlosity stacks - by BEAU - 28-01-2011, 07:32pm
RE: Verlosity stacks - by BEAU - 28-01-2011, 06:27pm



Users browsing this thread: 1 Guest(s)