13-07-2006, 04:07pm
I have 650cc Sard injectors in mine, but 550 might be alright for yours, Leonard will know for certain what size you need for that kit.
I had to drill out the throttle bodies where the injectors go, as well as make up some 12mm spacers for the fuel rail.
You will also need bigger grommets to fit the injectors.
I also bored out the fuel rail to 9.6mm(I think) just check the O ring size and take off 1.6mm.
I hope you didn't think the hard work was already done Graham, this is the bit where you start asking why the f*** did I start this.
Good luck
Dave <i></i>
I had to drill out the throttle bodies where the injectors go, as well as make up some 12mm spacers for the fuel rail.
You will also need bigger grommets to fit the injectors.
I also bored out the fuel rail to 9.6mm(I think) just check the O ring size and take off 1.6mm.
I hope you didn't think the hard work was already done Graham, this is the bit where you start asking why the f*** did I start this.
Good luck
Dave <i></i>