Contact Us
06-10-2009, 08:13am
gen2 rear wheel,disc and sprocket assemby is heavier than a gen1 setup despite the advertising hype.I weighed them both.
Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED
›
Bike Discussions
›
Technical Discussion
Gen2 swing arm on a gen1
Gen2 swing arm on a gen1
|
Gen2 swing arm on a gen1
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Gen2 swing arm on a gen1 - by Dan85 - 05-10-2009, 08:21pm
RE: Gen2 swing arm on a gen1 - by simmo - 05-10-2009, 09:04pm
RE: Gen2 swing arm on a gen1 - by Dan85 - 05-10-2009, 09:08pm
RE: Gen2 swing arm on a gen1 - by Legend - 05-10-2009, 10:50pm
RE: Gen2 swing arm on a gen1 - by REVIT13 - 05-10-2009, 10:53pm
RE: Gen2 swing arm on a gen1 - by Dan85 - 05-10-2009, 11:08pm
RE: Gen2 swing arm on a gen1 - by spamanglenn - 06-10-2009, 08:13am
RE: Gen2 swing arm on a gen1 - by Dan85 - 06-10-2009, 08:04pm
RE: Gen2 swing arm on a gen1 - by Camel - 07-10-2009, 07:07am
|
Users browsing this thread: 1 Guest(s)