14-06-2005, 11:36pm
Ok the TPS is throttle position sensor ,not switch.
Just as the choke lever is not a CHOKE lever,but a fast idle lever.
And as far as the dealer sevice mode switch to get a reading for your fault code,you dont need to make a switch,all you need is a piece of electrical wire with each end bared.Take out the plastic plug and stick the ends of the wire into each connector,its just loops the circuit.Then turn on the ignition and see what the dash is telling you. You can also use this to set you TPS.Go for it!I take no reponsability though. Phuck its the phantom!<i></i>
Just as the choke lever is not a CHOKE lever,but a fast idle lever.
And as far as the dealer sevice mode switch to get a reading for your fault code,you dont need to make a switch,all you need is a piece of electrical wire with each end bared.Take out the plastic plug and stick the ends of the wire into each connector,its just loops the circuit.Then turn on the ignition and see what the dash is telling you. You can also use this to set you TPS.Go for it!I take no reponsability though. Phuck its the phantom!<i></i>