Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Swingarm comming

Swingarm comming
Tony Nitrous
Guest
 
#17
16-09-2005, 05:05pm
Not sure what a 250 is going to do to the cornering,
but it must be better than the 360 you can get in the "states"
( short chain runs from gear box sprox to a 2nd shaft in the swingarm with 2 offset sprockets, running a chain down BOTH sides of the rear wheel, takes the new 360/18 tyre.

Tony. <i></i>
Reply


Messages In This Thread
Swingarm comming - by kawasuki - 13-09-2005, 08:18pm
Re: Swingarm comming - by pan - 13-09-2005, 09:49pm
Re: Swingarm comming - by pan - 13-09-2005, 09:55pm
Re: Swingarm comming - by 1hotBUSA - 13-09-2005, 09:55pm
Swingarm comming - by Blackkat - 13-09-2005, 10:48pm
Re: Swingarm comming - by 1hotBUSA - 14-09-2005, 07:31pm
Re: Swingarm comming - by pan - 14-09-2005, 10:20pm
stock lenght or extended - by kawasuki - 14-09-2005, 11:21pm
Re: stock lenght or extended - by CAS3234 - 15-09-2005, 12:21am
Re: stock lenght or extended - by kawasuki - 15-09-2005, 12:28am
Re: stock lenght or extended - by simmo - 15-09-2005, 02:38pm
Re: stock lenght or extended - by 1hotBUSA - 15-09-2005, 05:57pm
Re: stock lenght or extended - by Tony Nitrous - 15-09-2005, 06:58pm
Re: stock lenght or extended - by kawasuki - 15-09-2005, 09:23pm
Re: stock lenght or extended - by Xhiler8r - 15-09-2005, 09:25pm
Re: stock lenght or extended - by 1hotBUSA - 15-09-2005, 10:36pm
Re: stock lenght or extended - by Tony Nitrous - 16-09-2005, 05:05pm
Re: stock lenght or extended - by 1hotBUSA - 18-09-2005, 10:28pm
Re: stock lenght or extended - by Xhiler8r - 18-09-2005, 10:37pm
Re: stock lenght or extended - by Tony Nitrous - 19-09-2005, 08:13am
Re: JMC arms - by gazza414 - 19-09-2005, 10:32pm
Re: Swingarm comming - by Max - 22-09-2005, 01:47am
JMC arm - by kamakazebusa - 25-09-2005, 12:20pm
Re: JMC arm - by gazza414 - 26-09-2005, 01:51pm
Re: JMC arm - by simmo - 26-09-2005, 02:27pm
JMC arm - by kamakazebusa - 27-09-2005, 09:51pm
Re: JMC arm - by gazza414 - 28-09-2005, 08:16am



Users browsing this thread: 2 Guest(s)