Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
CYLINDER REBORING/ COATING

CYLINDER REBORING/ COATING
Banter
Guest
 
#6
22-04-2009, 05:42pm
TheShredder Wrote:Most in the states use

Millennium Technologies


http://www.mt-llc.com/

Apologies if this is a dumb question but why do you need to replace the coating, why canâ€t you just hone the bore out and replace with over sized rings. Is it that the metal under the coating is to weak or of a composition that requires the additional friction decrease for heat dispersion? I have read all the benefits in the ads and manual but whatâ€s the cost to benefit ratio and can you get away without it.
Reply


Messages In This Thread
CYLINDER REBORING/ COATING - by brooksy - 27-05-2008, 09:02am
RE: CYLINDER REBORING/ COATING - by abusa - 27-05-2008, 12:34pm
RE: CYLINDER REBORING/ COATING - by TheShredder - 27-05-2008, 04:35pm
RE: CYLINDER REBORING/ COATING - by Legend - 28-05-2008, 07:09pm
RE: CYLINDER REBORING/ COATING - by brooksy - 28-05-2008, 07:17pm
RE: CYLINDER REBORING/ COATING - by Banter - 22-04-2009, 05:42pm
RE: CYLINDER REBORING/ COATING - by Maj - 22-04-2009, 10:48pm
RE: CYLINDER REBORING/ COATING - by Banter - 23-04-2009, 05:39pm
RE: CYLINDER REBORING/ COATING - by mark - 24-04-2009, 08:03am
RE: CYLINDER REBORING/ COATING - by Maj - 24-04-2009, 09:03am
RE: CYLINDER REBORING/ COATING - by mark - 24-04-2009, 12:25pm
RE: CYLINDER REBORING/ COATING - by Banter - 24-04-2009, 11:10am
RE: CYLINDER REBORING/ COATING - by Maj - 24-04-2009, 02:12pm
RE: CYLINDER REBORING/ COATING - by Banter - 24-04-2009, 04:00pm
RE: CYLINDER REBORING/ COATING - by jzbusa - 25-04-2009, 01:00am
RE: CYLINDER REBORING/ COATING - by Maj - 25-04-2009, 06:28am



Users browsing this thread: 1 Guest(s)