Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › General Discussion v
GI Pro

GI Pro
BUSGO Offline
GEN II club

NSW Member
Posts: 5,303
Threads: 275
Joined: Mar 2007
Reputation: 9
#11
09-04-2009, 07:34am
Hutch99,
Set your idle speed to 1100rpm or even 1200rpm if you have a TRE or GIpro.
The bike will run much better.
You should have an idle adjuster knob just above the oil filler hole.
Set it when the bike is warm.
"If time catches up with you. You're going too slow!"
Regards BUSGO
Find
Reply


Messages In This Thread
GI Pro - by Hutch99 - 06-04-2009, 08:52pm
RE: GI Pro - by Pommie - 06-04-2009, 09:41pm
RE: GI Pro - by Hutch99 - 08-04-2009, 03:57pm
RE: GI Pro - by Pommie - 08-04-2009, 04:54pm
RE: GI Pro - by Maj - 08-04-2009, 06:20pm
RE: GI Pro - by Pommie - 08-04-2009, 07:36pm
RE: GI Pro - by Maj - 08-04-2009, 10:01pm
RE: GI Pro - by Pommie - 08-04-2009, 10:05pm
RE: GI Pro - by Hutch99 - 08-04-2009, 10:02pm
RE: GI Pro - by Hutch99 - 08-04-2009, 10:17pm
RE: GI Pro - by BUSGO - 09-04-2009, 07:34am
RE: GI Pro - by Hutch99 - 09-04-2009, 07:40am
RE: GI Pro - by Ozboc - 10-04-2009, 10:57am
RE: GI Pro - by VCM Cycle Seats - 10-04-2009, 11:11am
RE: GI Pro - by DAD - 10-04-2009, 11:28am
RE: GI Pro - by VCM Cycle Seats - 10-04-2009, 11:40am
RE: GI Pro - by Hutch99 - 10-04-2009, 06:06pm
RE: GI Pro - by Hutch99 - 10-04-2009, 06:09pm
RE: GI Pro - by Ozboc - 12-04-2009, 11:17am
RE: GI Pro - by VCM Cycle Seats - 10-04-2009, 06:23pm
RE: GI Pro - by Hutch99 - 10-04-2009, 07:02pm
RE: GI Pro - by Volvi - 12-04-2009, 12:00pm
RE: GI Pro - by VCM Cycle Seats - 12-04-2009, 12:21pm
RE: GI Pro - by Hutch99 - 12-04-2009, 06:21pm
RE: GI Pro - by Volvi - 12-04-2009, 06:25pm
RE: GI Pro - by VCM Cycle Seats - 12-04-2009, 06:43pm
RE: GI Pro - by Hutch99 - 12-04-2009, 06:50pm



Users browsing this thread: 3 Guest(s)