Charge Cooling

[aquajett]

hope this is helpfull I run a aquamist system 1s which is activated by a manifold pressure switch which is set at 8 psi i am using the smallest jet at the moment which is 0.5mm and with that jet the pressure is 130 psi the kit allso comes with a 0.6mm and 0.7mm jets i mainly choose water for the room factor and didnt want any air flow restrictions through a intercooler which was not big enough mine all so is only used on the street and runs about 15psi and as blackzook said has worked well so far i think off hand i paid about $700-800 for the kit which is the basic kit and then they step up to something like blackzook is running with the 3d mapping i have my jet in the elbow just before it goes through the frame so its got a bit off time to cool before the plenum you can see the position in members photos on page two my turbo busa streetbike enlarge photo for a good look
cheers aquajett