Contact Us
01-02-2009, 08:06pm
[attachment=5091]
Just make sure when you fit the meters to be real careful where you put em in the front plastic side panels cause there is only just enough room due to the depth length of the meters so may be good if you buy 2 spare plastic side panels www.alpha-sports.com
or www.bikebandit.com. Before you go drilling holes in your headers make sure you mark em off while the headers are fitted as only just enough room to fit and all should be equal distance from outlets.
Is good idea to fit push button red light switch on left panel for all 4 meters. Run black silicon/silastic or black marine sikaflex around the sides of the meters that have plastic spring clips fitted to the sides.
Next project, I've ordered another fender eliminator off Schnitz Racing then I'll cut that up and modify it so can fit a sh-itload more electrical boxes under there as you don't realy need that much clearance under the fender if you aint drag racing.
[attachment=5091]
Billy the kid Wrote:Thanks for the info gruntmax!
Just make sure when you fit the meters to be real careful where you put em in the front plastic side panels cause there is only just enough room due to the depth length of the meters so may be good if you buy 2 spare plastic side panels www.alpha-sports.com
or www.bikebandit.com. Before you go drilling holes in your headers make sure you mark em off while the headers are fitted as only just enough room to fit and all should be equal distance from outlets.
Is good idea to fit push button red light switch on left panel for all 4 meters. Run black silicon/silastic or black marine sikaflex around the sides of the meters that have plastic spring clips fitted to the sides.
Next project, I've ordered another fender eliminator off Schnitz Racing then I'll cut that up and modify it so can fit a sh-itload more electrical boxes under there as you don't realy need that much clearance under the fender if you aint drag racing.
[attachment=5091]