200 hp's!!

[GRUNTMAX]

Grunt you must realize that i do not have a k8 busa!This is from a busa forum i ripped it off!
The bike is de-restricted and is head ported.

Like you point out there is a need for a data logger to monitor the exhaust,the fact that there is a better way to do it is than the data logger does is another thing and i beg you to share the information on how i can get my hands on these probes!!

I have passed my suppliers info onto Jamie Bezzina of S & R Pro Performance and Products. www.sandrpro.com at Penrith in Sydney. You are best to send quotation request for EGT Digital Gauges by Email. They also have connectors on them where you can wire info into youre data logger. They are not a cheap item and he will want payment up front transfered into his account. The units themselves come with no warrantee but mine have been on for 30,000 KMs and still working OK. Jamie can be trusted. I know. Have dealt with him for several years now.
Cheers
Please note text below & pdf attachment. Probably about AUS$2,000.00 plus fitting costs for 4 of them or fit em yourself.
*************************************************
Hello, GRUNTMAX. It is indeed a pleasure to speak with you again.
Letâ€s see if we can figure this one out…
Do all of the meters read the correct ambient temperature once
they have cooled down again? Is it possible that the temperatures
had gone over +1300C? EEEE is an input signal out of range
warning.
Wiring should be:
EGT Probe:
Terminal 6: Red wire (-)
Terminal 7: Yellow wire (+)
Power Hookup:
Terminal 1: +12 VDC power
Terminal 2 Power ground
(See page 8 of the manual)
Next, you should confirm that the programâ€s Input Code is “# 6”
for a Type K thermocouple input device (page 3 of manual). This
can be set via the front panel push buttons switches. This is
explained on page 6 on the manual.

Note the attached manual.
You could probably contact Jamie at sandrpro@bigpond.net.au regards these units