26-08-2008, 08:40am
Remove the slide block off the end. With the right grip, unclamp the brake lever off the handle note there is a punch mark on the handle which is a reference point for where the brake clamps back on, I used a No 2 Phillips head bit from a drill and a small shifter to take apart the housing where the throttle cables are, the top lifts off leave all the wiring alone, take out the two Allen keys that hold the handle in place, it has a grove in the handle where one of the bolts clamps on so can only go back into position one way, once the handle is loose slide it forward towards the centre until the it is past the cable housing, try to get some slack in the cable then lift the grip and try pull the base out of the housing and lower it down then remove the two cables off the grip, read this backwards for re-install. Use this info as a guide only.