Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Remapping std ECU on the dyno

Remapping std ECU on the dyno
Slong
Guest
 
#11
24-02-2008, 06:54pm
Wow, this Petrik dude isn't even a software engineer!
Can a 32bit ECU & wiring loom swap straight over to replace a 16bit '00 one? - ie no extra sensors (assuming that sensors have same signalling range(?)).

Would be a project I'd like to do.
Reply


Messages In This Thread
Remapping std ECU on the dyno - by gazza414 - 16-02-2008, 10:30am
RE: Remapping std ECU on the dyno - by gazza414 - 16-02-2008, 12:36pm
RE: Remapping std ECU on the dyno - by Maj - 17-02-2008, 08:06am
RE: Remapping std ECU on the dyno - by abusa - 17-02-2008, 08:23am
RE: Remapping std ECU on the dyno - by A^K^T - 17-02-2008, 10:41am
RE: Remapping std ECU on the dyno - by Maj - 17-02-2008, 10:57am
RE: Remapping std ECU on the dyno - by abusa - 18-02-2008, 11:28pm
RE: Remapping std ECU on the dyno - by NEMESIS - 18-02-2008, 11:59pm
RE: Remapping std ECU on the dyno - by Maj - 19-02-2008, 06:49am
RE: Remapping std ECU on the dyno - by gazza414 - 23-02-2008, 12:38pm
RE: Remapping std ECU on the dyno - by Slong - 24-02-2008, 06:54pm
RE: Remapping std ECU on the dyno - by Legend - 24-02-2008, 08:12pm
RE: Remapping std ECU on the dyno - by Slong - 25-02-2008, 08:43am
RE: Remapping std ECU on the dyno - by Maj - 25-02-2008, 10:51am
RE: Remapping std ECU on the dyno - by Maj - 25-02-2008, 05:30pm
RE: Remapping std ECU on the dyno - by spamanglenn - 01-03-2008, 06:49am
RE: Remapping std ECU on the dyno - by gazza414 - 05-03-2008, 03:08pm



Users browsing this thread: 1 Guest(s)