Contact Us
18-01-2008, 06:23pm
Its hand laid, using a new type of superclear gelcoat. No pinholes. Plus i spray the gelcoat, not brush it on which causes an uneven surface for the carbon to sit on. Ive been testing it on my Busa since 04/12/07 about 2000km and its all good.
horndog, if you prepare the surface properly and use the correct release agent you shouldnt have a problem, also if you over catylize the resin your using you will create too much heat which will damage the original part , never use anymore that 2.5% catalyst as you will cook it or even worse start a fire.
Bear the mould is plain old fibreglass but the gelcoat i use is tooling gel specific for moulds.
spamanglenn i only use 1 coat of superclear gelcoat, with no pinholes at all. This stuff is great and i highly recomend it.
g bus66 I reckon the price would be around $100 delivered, i want to make sure they are perfect tho, so could be a few weeks off.
horndog, if you prepare the surface properly and use the correct release agent you shouldnt have a problem, also if you over catylize the resin your using you will create too much heat which will damage the original part , never use anymore that 2.5% catalyst as you will cook it or even worse start a fire.
Bear the mould is plain old fibreglass but the gelcoat i use is tooling gel specific for moulds.
spamanglenn i only use 1 coat of superclear gelcoat, with no pinholes at all. This stuff is great and i highly recomend it.
g bus66 I reckon the price would be around $100 delivered, i want to make sure they are perfect tho, so could be a few weeks off.