Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
wanting better brake power

wanting better brake power
Ruffy Offline
Ghost who walks
NSW Member
Posts: 779
Threads: 80
Joined: Mar 2007
Reputation: 1
#5
07-01-2008, 09:22pm
Mate - I've gone with the braided lines,floating disks and sintered pads front and rear. All up cost me around $1100 and they are more than up to the job, give good feel and plenty of confidence,don't look too bad eitherPi_thumbsup

[attachment=2068]

[attachment=2067]


Cheers Ruffy
Find
Reply


Messages In This Thread
wanting better brake power - by xxxdamoxxx - 07-01-2008, 11:04am
RE: wanting better brake power - by 2CUTE4U - 07-01-2008, 11:18am
RE: wanting better brake power - by Gnarbunkle99 - 07-01-2008, 12:50pm
RE: wanting better brake power - by ross79 - 24-08-2009, 07:19pm
RE: wanting better brake power - by kawasuki - 07-01-2008, 08:39pm
RE: wanting better brake power - by Ruffy - 07-01-2008, 09:22pm
RE: wanting better brake power - by 1300hayabusa - 08-01-2008, 08:21am
RE: wanting better brake power - by xxxdamoxxx - 08-01-2008, 12:37pm
RE: wanting better brake power - by Heidi1 - 08-01-2008, 12:59pm
RE: wanting better brake power - by kawasuki - 08-01-2008, 08:15pm
RE: wanting better printing power - by Ruffy - 08-01-2008, 09:04pm
RE: wanting better printing power - by kawasuki - 09-01-2008, 11:29am
RE: wanting better brake power - by 1hotbusa - 09-01-2008, 08:25pm
RE: wanting better brake power - by slowandsteady - 10-01-2008, 04:27pm
RE: wanting better brake power - by g bus66 - 10-01-2008, 05:28pm
RE: wanting better brake power - by spamanglenn - 10-01-2008, 05:37pm
RE: wanting better brake power - by Greeny_SA - 24-08-2009, 08:56pm
RE: wanting better brake power - by Madmax - 24-08-2009, 11:44pm
RE: wanting better brake power - by Greeny_SA - 25-08-2009, 01:00am
RE: wanting better brake power - by Madmax - 25-08-2009, 01:22am
RE: wanting better brake power - by xxxdamoxxx - 11-01-2008, 11:31pm



Users browsing this thread: 1 Guest(s)