Who's quickest on stock engined Gen2 now??

[01busa]

Jeremy Teasley went 8.42 on a stock motor busa with an 8 inch arm
Progressive numbers:

1.326
3.541
5.404 @ 135.04
7.035
8.423 @ 161.44

stock motor and i believe a stock clutch too.
I am saying that it is acheivable with a stock engine not
that everybody can do it

Looks like a lot of mp/h for a stock engine, but then again they are always better in the states

[abusa]

From dot.org
http://www.suzukihayabusa.org/forum/inde...c=147857.0

We run stock clutch and springs, gen 2 and stock motor at 65 inches no clutch mod either 180 lb rider goes 1.38 bike weights 485 on mr12. That rider been 8.62 @162. Bike went 8.42 @161.44 with JT at Rockingham. Got 105 passes on the Michelin too. I put a couple fibers and steels in it every, like 20-25 passes. If your clutch does anything funny or just for mantence,bleed that sucker and check for air. Gave me a fit while back. Oh and stock shock at full tight top and bottom. Goodluck.

Thanks Mike, its the stock motor world record . Come on up to Mirock and make a pass on it. You featherweights are bad boys. That was 95 degrees and humit like you got right now. Looking for a 35 in the fall from Ryan. With stock wheels and full dressed with street pipe. BST's, lose 8 more pounds and good air what you think?
1.326
3.541
5.404 @ 135.04
7.035
8.423 @ 161.44

Hard to believe this is with a hand clutch. Both JT and RS are feather weights at 60kg + gear.

[fullbore busa]

Thats the sort of mph i would expect to see with around 190-195hp , the guy can obviously ride tho with a et like that .

Jason well done u would be the quickest stock motor gen2 in aust that iv seen keep at it u will get that 8

Mark

[jamdonut]

Well done Jason

[Streeter.]

Heard on the grape vine Dan Peaty went 9.05 last weekend on his gen 2.

That must be the quickest stock engine gen 2 E.T. at the moment hey?

Nice going Dan.

[BLACKZOOK]

Incredible time mate, do you know what length he is at?

[Streeter.]

Incredible time mate, do you know what length he is at?

Not really. Only the first outing with that set up though for him. It ran the 9.05 @ only 130mph as he shut it off. Probably more a 9.01/9.02 across the line under power still.

Don't think it will be long before we see the first 8 out of a stocker/aspirated engined gen 2 in this country. Couple of real contenders around at the moment.

[dan]

G'day guys it sits at about 8 inch over,i did back it off but only a little it ran 145mph on the 9.05 pass.It had been running about 150mph on the other passes.

[Legend]

Great work Dan !!!

Thou I expect it from you.....

Leonard.

[BLACKZOOK]

Great riding mate congrats for the time.

At 8" over you wouldnt have much weight on the rear tyre.

[jason]

Yep well done thats for sure they will go 8s in a few more passes must be that secret squirrel tune

[Streeter.]

Sorry Dan 145mph correct. Don't know where I got the 130mph from.

Shit like that happens as you get older.

[REVIT13]

Well done Dan. Who will be 1st Dan or Jason into the 8's on similar setups. Would be good to see them both run a sub 9.00 at the same time :)

[dan]

hey jas i know a bloke who is a whizz at puttin killer tune ups into these bussas

[antduncan]

Well done Dan. Who will be 1st Dan or Jason into the 8's on similar setups. Would be good to see them both run a sub 9.00 at the same time :)

Could happen at the benaraby all bike so come on up for a look