Just want to know if someone is using a hahn,s port fueler ????
Want to step up to 10 psi boost and water injection, and wanted to know what is the best secondary fuel system to use and what water injection system is needed ....
RCC stage 1 running at 7 psi......
PICS ... A BIT OF FUN AT WORK, AFTER WE RAN THE ENGINE WITH NO OIL FOR 10MIN AND CHUCKED 3 RODS OUT OF BED....
I read that before scrolling down.... had me worried the bike was damaged....
Port fueler is a good looking system, couple of guys on Suzukihayabusa .org have used them and you could get an experianced users opinion there .
a little cheaper than a rcc upgrade but not much .
Aquamist would be the best water injection, top of the range have 3d mapping , base model is constant rate but still works fine. http://www.aquamist.co.uk/
horndog Wrote:Hey Darwin, what minesite is that? Thinking it is ERA cos generally you wouldnt bin an entire truck unless its contaminated.
Yes it is ERA it was a old truck we just got 10 new ones so the old trucks and dozers get pushed into the old pit, just keep the wheels off them and that is it. had fun blowing up the engine ...
horndog Wrote:Hey Darwin, what minesite is that? Thinking it is ERA cos generally you wouldnt bin an entire truck unless its contaminated.
Yes it is ERA it was a old truck we just got 10 new ones so the old trucks and dozers get pushed into the old pit, just keep the wheels off them and that is it. had fun blowing up the engine ...
I was just at ERA a couple of weeks ago visiting the maintenance planners. Small world.
There is no strong performance without a little fanaticism in the performer