Contact Us
This mod cost me $1.59. and it looks great.
Here is a step by step on how i did it.
1) Cut the mud flap off just under the tail light area.
2) I bought an 'L' shaped thing from a hardware shop, it is galvanised. for 21cents and 2 larger ones for 69cents each.
3) I drilled a hole through the bottom of my tray right at the rear in the middle so that the 'L' shape thing is centered.
4) I got my stock steel numberplate holder from my mudflap and drilled a hole in the middle just above the one thats already there, and then bolted it on.
5) I bolted the larger 'L' things onto the steel plateholder and then bolted the blinkers on and wired them up.
The end result, a nice fender eliminator that will do the trick until an undertail comes.
Picture below is with a after market undertail
[attachment=2667]
Here is a step by step on how i did it.
1) Cut the mud flap off just under the tail light area.
2) I bought an 'L' shaped thing from a hardware shop, it is galvanised. for 21cents and 2 larger ones for 69cents each.
3) I drilled a hole through the bottom of my tray right at the rear in the middle so that the 'L' shape thing is centered.
4) I got my stock steel numberplate holder from my mudflap and drilled a hole in the middle just above the one thats already there, and then bolted it on.
5) I bolted the larger 'L' things onto the steel plateholder and then bolted the blinkers on and wired them up.
The end result, a nice fender eliminator that will do the trick until an undertail comes.
Picture below is with a after market undertail
[attachment=2667]