Sump - making it low profile.

[Macbusa]

I'm wanting to lower the profile of my stock sump. The busa is lowered and i'm abit concerned i'lll punch the sump plug in if i have a hard landing from an unexpected wheelie.

It busa doesn't see the streets anymore. Do i have to worry about oil starvation or oil being pushed to the rear and starving on a hard launch?

Any tips or advice greatly appreciated.

Anyone willing to make it a low profile for some $$ for me?

[jason]

buy a 2inch lowered sump with a swinging pick up least you that its right then cheap ways not always best.

[Maj]

You would have less oil surge probs with a proper low profile sump and swinging pickup , but even they would need mods to fit a full exhaust .
otherwise its not that hard to cut ~30-40mm off and trim the pickup and breather tube, but if you start getting into the 1.5 60's start shopping for better
try Pete for the cut and shut

[abusa]

If you really want a cut sump I have one from McIntosh with a new Brocks baffle I would sell. Was used on a turbo bike, previous owner went to a billet sump which I ended doing the same for the extra clearance.