TRE

[Ronnie Ramjet]

I have a checkered flag TRE that has come apart from the connecting plugs.One side has red,black and blue wires ,the other has two blue and a black.I dont know which plug goes to which set of wires and in which order.Does anyone have a photo or diagram that may help me repair this or do I just get another one.

[fasterfaster]

Ronnie Greg (Maj) may have allready pmed you regards this and should be able to help you out
Sorry about the bit vague when you awoke me from slumber this morning Ron ................... you should have just said Ronnie Ramjet

[ROD]

Yeh sorry i was not at home to help You Ron hope you have sorted

[Maj]

No i haven't, but if you have a multimeter the circuitry should go
black straight through
one blue straight through
and depends if it came out of the male or female plug the last blue will be either open circuit or jump to the black with a 6.8k ohm resistance

[Ronnie Ramjet]

The wires have come out of both plugs,so dont know which set of wires go into what plug.

[Maj]

ok, look for the wire with 6.8kohm resistance between the black and either red or one of the blues, that coloured wire will be on the ecu side and join the pink, the other 2 wires in that group will plug into there own colour
then on the engine/gps side the colour that is open circuit goes to pink

[Ronnie Ramjet]

Thanks for that,will let you know how I get on

[Ronnie Ramjet]

Have successfully soldered the wires onto terminals and put into correct plugs.Refitted to bus and is working well again.Thanks guys for your help.Even have the speeding ticket to prove it.

[fasterfaster]

Ronnie don't tell me ya got busted whilst checking it ??? Bastards